Holla oruxmaps desde Portugal, muchas gracias por lo software...
i´m wondering to know if its possible ajust the average speed or the auto-pause??
im allready put 1sec on the settings "auto segment no move" when i stop it stops counting, but when i start the time increase...
so in the end the avegrage speed is incorrect.
exists some settings to correct the problem??
apreciate,
greetings!
Duarte
Quote from: "umek"
i´m wondering to know if its possible ajust the average speed or the auto-pause??
im allready put 1sec on the settings "auto segment no move" when i stop it stops counting, but when i start the time increase...
so in the end the avegrage speed is incorrect.
exists some settings to correct the problem??
apreciate,
greetings!
Duarte
Hola Duarte,
Ese ajuste no puede tener un valor inferior a 15 segundos; utiliza un valor mayor o igual que 15 segundos.
orux
Holla orux,
gracias!!
But 15sec it´s so much time until it stops counting, could you reduce some seconds?? to 5s or 3s??
it was a nice improvement in the software ;)
Keep up the good work, i love my navigator oruxmaps!!!!!
Greetings from Portugal!
[[]]
Hell again, ;)
I tried with 15sec and happens the same, when i stop the ride he stops counting, but when i start the ride again he increase the time i´ve been stopped. could you fix this bug???
greetings,
Umek
Quote from: "umek"
I tried with 15sec and happens the same, when i stop the ride he stops counting, but when i start the ride again he increase the time i´ve been stopped. could you fix this bug???
greetings,
Umek
Hola;
Creo que estás viendo los datos totales, no los de cada segmento, vete a configuración--interfaz usuario--dashboard--> hay un ajuste que permite que en el cuadro de mandos se vean los datos (distancia, tiempo,...) del track completo o del último segmento.
orux
Quote from: "orux"
Quote from: "umek"
I tried with 15sec and happens the same, when i stop the ride he stops counting, but when i start the ride again he increase the time i´ve been stopped. could you fix this bug???
greetings,
Umek
Hola;
Creo que estás viendo los datos totales, no los de cada segmento, vete a configuración--interfaz usuario--dashboard--> hay un ajuste que permite que en el cuadro de mandos se vean los datos (distancia, tiempo,...) del track completo o del último segmento.
orux
Holla Orux :D :D
Gracias, esta funcionando ;) :D
Keep up the good work :P
Un Saludo desde Portugal!